Qlogic SANbox 5602 User Manual page 197

0
Examples
The following is an example of the Set Config Port command:
SANbox Manager #> admin start
SANbox Manager (admin) #> config edit
SANbox Manager (admin-config) #> set config port 1
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Configuring Port Number:
------------------------
AdminState
LinkSpeed
PortType
SymPortName
ALFairness
DeviceScanEnable (True / False)
ForceOfflineRSCN (True / False)
ARB_FF
InteropCredit (decimal value, 0-255)
ExtCredit
FANEnable
AutoPerfTuning (True / False)
LCFEnable
MFSEnable
VIEnable
MSEnable
NoClose
IOStreamGuard (Enable / Disable / Auto)
PDISCPingEnable
Finished configuring attributes.
This configuration must be saved (see config save command) and
activated (see config activate command) before it can take effect.
To discard this configuration use the config cancel command.
SANbox Manager (admin-config) #>
59097-00 A
1
(1=Online, 2=Offline, 3=Diagnostics, 4=Down)
(1=1Gb/s, 2=2Gb/s, 3=Auto)
(GL / G / F / FL / Donor)
(string, max=32 chars)
(True / False)
(True / False)
(dec value, increments of 15, non-loop only)
(True / False)
(True / False)
(True / False)
(True / False)
(True / False)
(True / False)
(True / False)
A – Command Line Interface
Set Config Command
[Online]
[Auto ]
[GL ]
[Port1 ]
[False ]
[True ]
[False ]
[False ]
[0 ]
[0 ]
[True ]
[False ]
[False ]
[False ]
[False ]
[True ]
[False ]
[Disable]
[True ]
A-47