Qlogic SANbox 5602 User Manual page 216

A – Command Line Interface
Show Command
PrimSeqErrors
RxLinkResets
RxOfflineSeq
TotalErrors
TotalLIPsRecvd
TotalLIPsXmitd
TotalLinkResets
TotalOfflineSeq
TotalRxFrames
TotalRxWords
TotalTxFrames
TotalTxWords
TxLinkResets
TxOfflineSeq
post log
Displays the Power On Self Test (POST) log which contains results from the most
recently failed POST.
setup [option]
Displays setup attributes for the system, SNMP, and the switch manufacturer.
Refer to the
steering [domain_id]
Displays the routes that data takes to the switch given by [domain_id]. If you omit
[domain_id], the system displays routes for all switches in the fabric.
A-66
Table A-15. Show Port Parameters (Continued)
Entry
Primitive sequence errors detected.
Number of link reset primitives received from an attached
device.
Number of offline sequences received. An OLS is issued
for link initialization, a Receive & Recognize
Not_Operational (NOS) state, or to enter the offline state.
Total number of errors detected.
Number of loop initialization primitive frames received by
this port.
Number of loop initialization primitive frames transmitted
by this port.
Total number of link reset primitives.
Total number of Offline Sequences issued and received by
this port.
Total number of frames received by this port.
Total number of words received by this port.
Total number of frames issued by this port.
Total number of words issued by this port.
Number of Link Resets issued by this port.
Total number of Offline Sequences issued by this port.
"Show Setup Command" on page
Description
A-87.
0
59097-00 A