Displaying Hardware Status; Hardware Status Leds - Qlogic SANbox 5602 User Manual

0
3. Click the Start button to begin the firmware load process. You will be shown
a message warning you that the switch will be reset in order to activate the
firmware.
4. Click the OK button to continue firmware installation or click the Cancel
button to cancel the firmware installation.
4.14

Displaying Hardware Status

To display a summary of the hardware status information in a popup text box, rest
the cursor over the chassis LED cluster in the faceplate display.
Input Power LED - indicates the voltage status of the switch.
Heartbeat LED - indicates the status of the internal switch processor and the
results of the POST.
System Fault LED - indicates an over temperature condition or a Power On
Self Test error.
59097-00 A
Figure 4-15. Hardware Status LEDs
4 – Managing Switches
Displaying Hardware Status
4-35