Qlogic SANbox 5602 User Manual page 175

0
2. Move to the folder or directory on the workstation that contains the new
firmware image file.
3. Establish communications with the switch using the File Transfer Protocol
(FTP). Enter one of the following on the command line:
or
where xxx.xxx.xxx.xxx is the switch IP address, and switchname is the
switch name associated with the IP address.
4. Enter the following account name and password:
5. Activate binary mode and copy the firmware image file on the switch:
6. Wait for the transfer to complete, then close the FTP session.
7. Establish communications with the switch using the CLI. Enter one of the
following on the command line:
or
where xxx.xxx.xxx.xxx is the switch IP address, and switchname is the
switch name associated with the IP address.
8. A Telnet window opens prompting you for a login. Enter an account name
and password. The default account name and password are (admin,
password).
9. Open an Admin session to acquire the necessary authority.
10. Display the list of firmware image files on the switch to confirm that the file
was loaded.
11. Unpack the firmware image file to install the new firmware in flash memory.
59097-00 A
>ftp xxx.xxx.xxx.xxx
>ftp switchname
user:images
password: images
ftp>bin
ftp>put filename
xxxxx bytes sent in xx secs.
ftp>quit
telnet xxx.xxx.xxx.xxx
telnet switchname
SANbox Manager $>admin start
SANbox Manager (admin) $>image list
SANbox Manager (admin) $>image unpack filename
A – Command Line Interface
Image Command
A-25