Qlogic SANbox 5602 User Manual page 156

A – Command Line Interface
Working with Switch Configurations
The restore process replaces all configuration information on the switch and
afterwards the switch is automatically reset. If the restore process changes the IP
address, all management sessions are terminated. Use the Set Setup System
command to return the IP configuration to the values you want. Refer to the
Setup Command" on page
then enter the Config Restore command from within an Admin session as shown:
SANbox Manager
SANbox Manager (admin) #> config restore
A-6
A-57. To restore the switch, open a Telnet session,
#> admin start
The switch will be reset after restoring the configuration.
Please confirm (y/n): [n] y
0
"Set
59097-00 A