Qlogic SANbox 5602 User Manual page 190

A – Command Line Interface
Set Config Command
PortType
SymbolicPortName
ALFairness
(1-Gbps/2-Gbps ports
only)
DeviceScanEnabled
ForceOfflineRSCN
ARB_FF
(1-Gbps/2-Gbps ports
only)
InteropCredit
ExtCredit
(1-Gbps/2-Gbps ports
only)
FANEnable
(1-Gbps/2-Gbps ports
only)
A-40
Table A-9. Set Config Port Parameters (Continued)
Parameter
Port type:
Descriptive name for the port. The name can be up to
32 characters excluding #, semicolon (;), and comma
(,). The default is Port n where n is the port number.
Arbitration loop fairness. Enables (True) or disables
(False) the switch's priority to arbitrate on the loop.
The default is False.
Enables (True) or disables (False) the scanning of the
connected device for FC-4 descriptor information
during login. The default is True.
Enables (False) or disables (True) the immediate
transmission of RSCN messages when
communication between a port and a device is
interrupted. If enabled, the RSCN message is delayed
for 200 ms for locally attached devices and 400 ms for
devices connected through other switches. The
default is False. This parameter is ignored if
IOStreamGuard is enabled.
Send ARB_FF (True) instead of IDLEs (False) on the
loop. The default is False.
Interoperability credit. The number of buffer-to-buffer
credits per port. 0 means the default (16) is
unchanged. Changing interoperability credits is
necessary only for E_Ports that are connected to
non-FC-SW-2-compliant switches. Contact your
authorized maintenance provider for assistance in
using this feature.
Extended credits. The number of port buffer credits
that this port can acquire from donor ports. The
default is 0.
Fabric address notification. Enables (True) or disables
(False) the communication of the FL_Port address,
port name, and node name to the logged-in NL_Port.
The default is True.
Description
1-Gbps/2-Gbps Ports: GL, G, F, FL, Donor. The
default is GL.
10-Gbps Ports: G
0
59097-00 A