Installing Expansion Modules
Install a Versatile Interface Module in a 5520 Series Switch
Install an SSD Module
This chapter describes how to install expansion modules:
•
Versatile interface modules (VIM5s)
•
Solid-state Drive (SSD) modules
Note
Read the information in this chapter thoroughly before trying install or remove
an expansion module.
Install a Versatile Interface Module in a 5520 Series Switch
This section describes how to install a versatile interface module (VIM) in the front slot
of a 5520 Series switch.
You need the following tools and materials to install a VIM:
•
ESD-preventive wrist strap
•
Flat head screwdriver
Caution
Extreme Networks VIMs are not hot-swappable. Disconnect power to the
switch before removing an installed VIM or installing a new VIM.
To install a versatile interface module, follow these steps:
1. Attach the ESD wrist strap to your wrist and connect the metal end to an
appropriate ground point on the rack.
2. Ensure that the switch is completely powered down.
56
VSP 4900 Series Switches: Hardware Installation Guide
on page 57
on page 56