Preparing The Cables; Installing The Power Supply - Extreme Networks Summit X150 Series Hardware Installation Manual

Chapter 6: Installing Summit Family Switches

Preparing the Cables

A ring terminal and two spade terminals are provided with the power supply. You need a crimping tool
to attach the terminals to the power and ground cables.
To prepare the cables:
1 On each wire, strip 0.25 inch (6.35 mm) of insulation from one end.
2 Insert the stripped wire end all the way into the barrel of the terminal
terminal securely to the wire.
Be sure to attach the ring terminal to the green/yellow wire.
Figure 174: Attaching Terminals to Cables
Power connection wire

Installing the Power Supply

CAUTION
The handle on the Summit 300 W DC power supply is not designed to be used to lift or carry the
Summit X460 series switch.
To install a DC power supply in a Summit X460 series switch:
1 Attach an ESD-preventive wrist strap to your bare wrist and connect the metal end to an appropriate
ground point on the rack.
2 If necessary, remove a blank panel from the back of the Summit X460 series switch
Figure 175: Removing a Blank Panel
230
SH_109
SH_207
Summit Family Switches Hardware Installation Guide
(Figure 174) and crimp the
Ground wire
(Figure 175).
SH