Qos Over Fc Routers; Figure 69 Qos With E_Ports Enabled - HP StoreFabric SN6500B Administrator's Manual

NOTE
By default, QoS is enabled on 8-Gbps ports, except for long-distance 8-Gbps ports. QoS is disabled
by default on all 4-Gbps ports and long-distance 8-Gbps ports.
FIGURE 69
You need to enable QoS on the E_Ports on both ISLs between domain 3 and domain 4, because
either path might be selected to carry the traffic.
You do not need to enable QoS on the E_Ports on the ISLs between domain 1 and domain 2 and
between domain 2 and domain 3, because these are not the shortest paths between the hosts and
the targets. However, if the ISL between domain 1 and domain 3 is broken, then the path through
domain 2 would be used.
To guarantee traffic priority, you should enable QoS on all possible E_Ports. Alternatively, you could
use a TI zone to limit the E_Ports that carry the traffic between a "host,target" pair and enable QoS
on only those E_Ports.
If QoS is not enabled on an E_Port, the traffic prioritization stops at that point. For example, in
Figure 69
would be low priority from the hosts to domain 3, but would switch to the default (medium) priority
from domain 3 to the target S3.

QoS over FC routers

QoS over FC routers uses QoS traffic prioritization between devices in edge fabrics over an FC
router. See
phantom switches, and the FC-FC Routing Service.
To establish QoS over FC routers, you must do the following:
•
•
•
•
See
instructions.
Fabric OS Administrator's Guide
53-1002745-02
H1
H2
= Low priority
= Medium priority
= High priority
= E_Ports with
QoS enabled
QoS with E_Ports enabled
if you disabled QoS on E_Ports "3,12" and "3,13," then the traffic from H1 and H2 to S3
Chapter 24, "Using FC-FC Routing to Connect Fabrics,"
Define QoS zones in each edge fabric.
Define LSAN zones in each edge fabric.
Enable QoS on the E_Ports in each edge fabric.
Enable QoS on the EX_Ports in the backbone fabric.
"Setting QoS zone-based traffic prioritization over FC routers"
Domain 1
1
3
15
16
Domain 2
QoS zones
Domain 3
9
14
12
13
8
7
Domain 4
for information about FC routers,
on page 532 for detailed
21
S1
S2
S3
527