HP StoreFabric SN6500B Administrator's Manual page 67

5. You can confirm that the change has been made using the ipAddrShow command.
Example of enabling DHCP for IPv4 interactively:
Example of enabling DHCP for IPv4 using a single command:
Disabling DHCP for IPv4
When you disable DHCP, enter the static Ethernet IP address and subnet mask of the switch and
default gateway address. Otherwise, the Ethernet settings may conflict with other addresses
assigned by the DHCP server on the network.
Use the following procedure to disable DHCP for IPv4:
1. Connect to the switch and log in using an account assigned to the admin role.
2. Enter the ipAddrSet command.
3. Enter the network information using IPv4 dotted-decimal notation.
4. You can skip the Fibre Channel prompts by pressing Enter.
5. When you are prompted for DHCP[On], disable it by entering off.
6. You can confirm that the change has been made using the ipAddrShow command.
Example of disabling DHCP for IPv4 interactively:
Fabric OS Administrator's Guide
53-1002745-02
switch:admin> ipaddrset
Ethernet IP Address [10.1.2.3]:
Ethernet Subnetmask [255.255.255.0]:
Fibre Channel IP Address [220.220.220.2]:
Fibre Channel Subnetmask [255.255.0.0]:
Gateway IP Address [10.1.2.1]:
DHCP [Off]:on
switch:admin>
switch:admin> ipaddrset –ipv4 -add -dhcp ON
switch:admin> ipaddrshow
SWITCH
Ethernet IP Address: 10.20.134.219
Ethernet Subnetmask: 255.255.240.0
Gateway IP Address: 10.20.128.1
DHCP: On
switch:admin>
ipaddrset
NOTE
Alternatively, you can disable DHCP for IPv4 by entering "
"as a single command. If you do so, you do not need to complete the
ipv4 -add -dhcp OFF
following steps.
NOTE
If a static Ethernet address is not available when you disable DHCP, enter 0.0.0.0 at the
Ethernet IP address prompt.
switch:admin> ipaddrset
Ethernet IP Address [10.1.2.3]:
Ethernet Subnetmask [255.255.255.0]:
Gateway IP Address [10.1.2.1]:
The switch Ethernet interface
ipaddrset –
2
67