Assigning Backbone Fabric Ids; Fcip Tunnel Configuration - HP StoreFabric SN6500B Administrator's Manual

24

FCIP tunnel configuration

ATTENTION
In a multi-switch backbone fabric, modification of the FID within the backbone fabric will cause
disruption to local traffic.

Assigning backbone fabric IDs

1. Log in to the switch or Backbone.
2. Enter the switchDisable command if EX_Ports are online.
3. Enter the fosConfig --disable fcr command to disable the FC-FC routing service.
4. Enter the fcrConfigure command. At the prompt, enter the fabric ID, or press Enter to keep the
5. Verify the backbone fabric ID is different from that set for edge fabrics.
6. Enter the fosConfig --enable fcr command.
7.
Example
FCIP tunnel configuration
The optional Fibre Channel over IP (FCIP) Tunneling Service enables you to use "tunnels" to
connect instances of Fibre Channel SANs over IP-based networks to transport all Fibre Channel ISL
and IFL traffic. FCIP is a prerequisite for configuring VEX_Ports; if you are only using FC_Ports, then
there is no need to configure FCIP tunnels.
If using FCIP in your FC-FC routing configuration, you must first configure FCIP tunnels. Once a
tunnel is created, it defaults to a disabled state. Then configure the VE_Port or VEX_Port. After the
appropriate ports are configured, enable the tunnel.
NOTE
FCIP tunnel configuration is applicable only to Fabric OS fabrics and does not apply to Brocade
Network OS or M-EOS fabrics.
582
The default state for the FCR is disabled.
current fabric ID, which is displayed in brackets.
Multiple FC routers attached to the same backbone fabric must have the same backbone
fabric ID.
Enter the switchEnable command.
switch:admin> switchdisable
switch:admin> fosconfig --disable fcr
FC Router service is disabled
switch:admin> fcrconfigure
FC Router parameter set. <cr> to skip a parameter
Please make sure new Backbone Fabric ID does not conflict with any configured
EX-Port's Fabric ID
Backbone fabric ID: (1-128)[128]
switch:admin> fosconfig --enable fcr
FC Router service is enabled
switch:admin> switchenable
Fabric OS Administrator's Guide
53-1002745-02