21
Setting QoS zone-based traffic prioritization over FC routers
Setting QoS zone-based traffic prioritization over FC routers
1. Connect to the switch in the edge fabric and log in using an account with admin permissions.
2. Create QoS zones in the edge fabric.
3. Create LSAN zones in the edge fabric.
4. Enter the portCfgQos command to enable QoS on the E_Ports.
5. Repeat
6. Connect to the FC router in the backbone fabric and log in using an account with admin
7.
Disabling QoS zone-based traffic prioritization
1. Connect to the switch and log in using an account with admin permissions.
2. Enter the cfgRemove command to remove the QoS zones from the current zone configuration.
3. Enter the portCfgQos command to disable QoS on the E_Ports.
532
The QoS zones must have WWN members only, and not D,I members. See
zone-based traffic prioritization"
See
"Controlling device communication with the LSAN"
step 1
through
step 3
permissions.
Enter the portCfgQos command to enable QoS on the EX_Ports.
on page 530 for instructions.
to create QoS zones and LSAN zones on the other edge fabric.
"Setting QoS
on page 591 for instructions.
Fabric OS Administrator's Guide
53-1002745-02