Ti Zones Within A Backbone Fabric; Figure 40 Ti Zone In A Backbone Fabric - HP StoreFabric SN6500B Administrator's Manual

TI zones within a backbone fabric

A TI zone within a backbone fabric is used to route traffic within the backbone fabric through a
particular ISL. For example, in
traffic between EX_Ports "1,1" and "2,1" is routed through VE_Ports "1,4" and "2,7".
FIGURE 40
TI zones within the backbone fabric use the port WWN instead of D,I notation for devices that are to
communicate across fabrics. (You can use the portShow command to obtain the port WWN.)
Port WWNs should be used only in TI zones within a backbone fabric and should not be used in
other TI zones.
Using D,I and port WWN notation, the members of the TI zone in
•
•
•
•
•
•
•
Fabric OS Administrator's Guide
53-1002745-02
WWN
Host
Edge fabric 1
3
2
1
FC router 1
= Dedicated Path
= Ports in the TI zone
TI zone in a backbone fabric
1,1 (EX_Port for FC router 1)
1,4 (VE_Port for FC router 1)
2,7 (VE_Port for FC router 2)
2,1 (EX_Port for FC router 2)
10:00:00:00:00:01:00:00 (Port WWN for the host)
10:00:00:00:00:02:00:00 (Port WWN for target 1)
10:00:00:00:00:03:00:00 (Port WWN for target 2)
Traffic Isolation Zoning over FC routers
Figure 40, a TI zone is set up in the backbone fabric to ensure that
Backbone fabric
4 7
VE_Ports
5 8
6 9
Target 1
WWN
WWN
Edge fabric 2
1
Edge fabric 3
2
3
FC router 2
Figure 40 are:
12
Target 2
Target 3
355