Setting Up Ti Over Fcr (Sample Procedure); Figure 47 Ti Over Fcr Example - HP StoreFabric SN6500B Administrator's Manual

Fabric os administrator's guide, 7.1.0 (53-1002745-02, march 2013)
Hide thumbs Also See for StoreFabric SN6500B:
Table of Contents

Advertisement

Setting up TI over FCR (sample procedure)

The following example shows how to set up TI zones over FCR to provide a dedicated path shown in
Figure
the backbone fabric. The combination of these three TI zones creates a dedicated path for traffic
between Host 1 in edge fabric 1 and Targets 1 and 2 in edge fabric 2.
Host 1 has port WWN 10:00:00:00:00:08:00:00
Target 1 has port WWN 10:00:00:00:00:02:00:00
Target 2 has port WWN 10:00:00:00:00:03:00:00
Host 1
Edge fabric 1
FIGURE 47
NOTE
In the following procedure the three TI zones in the edge and backbone fabrics are all given the same
name, TI_Zone1. It is not required that the TI zones have the same name, but this is done to avoid
confusion. If several dedicated paths are set up across the FC router, the TI zones for each path can
have the same name.
1. In each edge fabric, set up an LSAN zone that includes Host 1, Target 1, and Target 2, so these
2. Log in to the edge fabric 1 and set up the TI zone.
E1switch:admin> fabricshow
Switch ID
-------------------------------------------------------------------------
1: fffc01 50:00:51:e3:95:36:7e:04
4: fffc04 10:00:00:60:69:80:1d:bc
6: fffc06 50:00:51:e3:95:48:9f:a0
Fabric OS Administrator's Guide
53-1002745-02
47. In this example, three TI zones are created: one in each of the edge fabrics and one in
8
5
Domain ID = 4
= Dedicated path set up by TI zone in edge fabric 1
= Dedicated path set up by TI zone in edge fabric 2
= Dedicated path set up by TI zone in backbone fabric
TI over FCR example
devices can communicate with each other. See
Fabrics,"
for information about creating LSAN zones.
a. Enter the fabricShow command to display the switches in the fabric. From the output, you
can determine the front and translate domains.
Worldwide Name

Setting up TI over FCR (sample procedure)

Domain ID = 1
Domain ID = 2
9
1
7
4
Backbone
fabric
Chapter 24, "Using FC-FC Routing to Connect
Enet IP Addr
0.0.0.0
10.32.72.4
0.0.0.0
Target 1
Target 2
2
3
6
Edge fabric 2
Domain ID = 9
FC IP Addr
Name
0.0.0.0
"fcr_fd_1"
0.0.0.0
>"E1switch"
0.0.0.0
"fcr_xd_6_9"
12
371

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fabric os 7.1.0

Table of Contents