HP StoreFabric SN6500B Administrator's Manual page 365

Example TI zone creation
The following examples create a TI zone named "bluezone", which contains E_Ports 1,1 and 2,4
and N_Ports 1,8 and 2,6.
To create a TI zone with failover enabled and in the activated state (default settings):
To create a TI zone with failover enabled (the zone is set to the activated state by default):
To create a TI zone with failover disabled and the state set to activated:
To create a TI zone and set the state to deactivated (failover is enabled by default):
To create a TI zone with failover disabled and the state set to deactivated:
To create a TI zone in the edge fabric with failover enabled and the state set to activated (default
settings):
To create a TI zone in the backbone fabric with failover enabled and the state set to activated
(default settings):
To create TI zones in a logical fabric, such as the one shown in
Remember that your changes are not enforced until you enter the cfgEnable command, as shown
here:
Fabric OS Administrator's Guide
53-1002745-02
switch:admin> zone --create -t ti bluezone -p "1,1; 2,4; 1,8; 2,6"
switch:admin> zone --create -t ti -o f bluezone -p "1,1; 2,4; 1,8; 2,6"
switch:admin> zone --create -t ti -o an bluezone -p "1,1; 2,4; 1,8; 2,6"
switch:admin> zone --create -t ti -o d bluezone -p "1,1; 2,4; 1,8; 2,6"
switch:admin> zone --create -t ti -o dn bluezone -p "1,1; 2,4; 1,8; 2,6"
switch:admin> zone --create -t ti bluezone -p "1,1; 1,8; 2,-1; 3,-1"
switch:admin> zone --create -t ti backbonezone -p "10:00:00:04:1f:03:16:f2;
1,1; 1,4; 2,7; 2,1; 10:00:00:04:1f:03:18:f1, 10:00:00:04:1f:04:06:e2"
Log in to the logical switch FID1, Domain 7 and create a TI zone in the logical fabric with FID=1:
LS1> zone --create -t ti -o f "ti_zone1" -p "8,8; 8,1; 3,3; 3,10; 5,16; 5,8;
9,5; 9,9"
Then create a TI zone in the base fabric, as described in
switch:admin> cfgenable "USA_cfg"
You are about to enable a new zoning configuration.
This action will replace the old zoning configuration with the
current configuration selected.
If the update includes changes to one or more traffic isolation zones, the
update may result in localized disruption to traffic on ports associated with
the traffic isolation zone changes
Do you want to enable 'USA_cfg' configuration (yes, y, no, n): [no] y
zone config "USA_cfg" is in effect
Updating flash ...
Creating a TI zone
Figure 43 on page 362:
"Creating a TI zone in a base
12
fabric".
365