HP StoreFabric SN6500B Administrator's Manual page 547

TABLE 80
Category
DCC Policy
Default Area
Downgrade
Fastwrite
FICON
HA Sync
Long Distance
Management Server Registered Node ID (RNID), Link Incident Record Registration (LIRR), and Query Security
NPIV
PID format
Port mirroring
Port Swap
Port Types
PWWN
QoS
Routing
Fabric OS Administrator's Guide
53-1002745-02
F_Port masterless trunking considerations (Continued)
Description
DCC policy enforcement for the F_Port trunk is based on the Trunk Area; the FDISC requests
to a trunk port are accepted only if the WWN of the attached device is part of the DCC policy
against the TA. The PWWN of the FLOGI sent from the AG will be dynamic for the F_Port
trunk master. Because you do not know ahead of time what PWWN the AG will use, the
PWWN of the FLOGI will not go through DCC policy check on an F_Port trunk master.
However, the PWWN of the FDISC will continue to go through DCC policy check.
Port X is a port that has its Default Area the same as its Trunk Area. The only time you can
remove port X from the trunk group is when the entire trunk group has the Trunk Area
disabled.
You can have trunking on, but you must disable the trunk ports before performing a
firmware downgrade.
ATTENTION
Removing a Trunk Area on ports running traffic is disruptive, because you must
disable the port to disable the Trunk Area on the port. Use caution before assigning a
Trunk Area if you need to downgrade to a firmware version earlier than Fabric OS
v6.2.0.
When you assign a Trunk Area to a trunk group, the trunk group cannot have FastWrite
enabled on those ports. If a port is FastWrite-enabled, the port cannot be assigned a Trunk
Area.
FICON is not supported on F_Port trunk ports. However, FICON can still run on ports that are
not F_Port trunked within the same switch.
If you plug in a standby CP with a firmware version earlier than Fabric OS v6.2.0 and a
Trunk Area is present on the switch, the CP blades will become out of sync.
Long distance is not allowed on F_Port trunks, which means that a Trunk Area is not
allowed on long-distance ports. You cannot enable long distance on ports that have a Trunk
Area assigned to them.
Attribute (QSA) ELSs are not supported on F_Port trunks.
Supported on F_Port master trunk.
F_Port trunking is supported only in the CORE PID format.
Port mirroring is not supported on Trunk Area ports or on the PID of an F_Port trunk port.
Port mirroring is not supported on the Brocade Encryption Switch.
When you assign a Trunk Area to a trunk group, the Trunk Area cannot be port swapped. If a
port is swapped, then you cannot assign a Trunk Area to that port.
Only F_Port trunk ports are allowed on a Trunk Area port. All other port types are
persistently disabled.
The entire Trunk Area trunk group shares the same Port WWN within the trunk group. The
PWWN is the same across the F_Port trunk that has 0x2f or 0x25 as the first byte of the
PWWN. The TA is part of the PWWN in the format listed in
Supported.
Routing will route against the F_Port trunk master. Bandwidth information will be modified
accordingly as the F_Port trunk forms.
22
F_Port trunking
Table 81 on page 548.
547