Backbone-To-Edge Routing With Virtual Fabrics; Figure 83 Logical Representation Of Ex_Ports In A Base Switch - HP StoreFabric SN6500B Administrator's Manual

24
FC-FC routing and Virtual Fabrics
FIGURE 83

Backbone-to-edge routing with Virtual Fabrics

Backbone-to-edge routing is not supported in the base switch, unless you use a legacy FC router.
A legacy FC router is an FC router configured on a Brocade 7500 switch.
Base switches can participate in a backbone fabric with legacy FC routers. You cannot connect
devices to the base switch because the base switch does not allow F_Ports. You can, however,
connect devices to the legacy FC router, thus enabling backbone-to-edge routing.
If you connect a legacy FC router to a base switch, you must set the backbone FID of the FC router
to be the same as that of the base switch.
In Figure
switches cannot have F_Ports.
switch. This FC router can have devices connected to it, and so you can have backbone-to-edge
routing through this FC router. In this figure, Host A in the backbone fabric can communicate with
device B in the edge fabric with FID 20; Host A cannot communicate with device C, however,
because the base switches do not support backbone-to-edge routing.
608
Edge fabric
Fabric 128
SW5
SW1
E
EX
SW4
Backbone fabric
Fabric 8
Logical representation of EX_Ports in a base switch
82, no devices can be connected to the backbone fabric (Fabric 8) because base
Edge fabric
Fabric 15
SW3
SW7
E
EX
SW8
Figure 84 shows an FC router in legacy mode connected to a base
SW2
SW6
Fabric 1
Fabric OS Administrator's Guide
53-1002745-02