Configuring Logical Switches To Use Basic Configuration Values - HP StoreFabric SN6500B Administrator's Manual

Fabric os administrator's guide, 7.1.0 (53-1002745-02, march 2013)
Hide thumbs Also See for StoreFabric SN6500B:
Table of Contents

Advertisement

Use the following procedure to disable Virtual Fabrics mode:
1. Connect to the physical chassis and log in using an account with the chassis-role permission.
2. Use the fosConfig command to check whether VF mode is disabled:
3. Move all ports to the default logical switch.
4. Delete all of the non-default logical switches.
5. Use the fosConfig command to disable VF mode:
6. Enter y at the prompt.
Example
The following example checks whether VF mode is enabled or disabled and then disables it.

Configuring logical switches to use basic configuration values

All switches in the fabric are configured to use the same basic configuration values. When you
create logical switches, the logical switches might have different configuration values than the
default logical switch. Use the following procedure to ensure that newly created logical switches
have the same basic configuration values as the default logical switch.
NOTE
For most users, you do not need to run this procedure. Contact your switch service provider to
determine if you need to use this procedure.
You need to run this procedure only once on each chassis, after you enable Virtual Fabrics but
before you create logical switches. The configuration settings are then preserved across reboots
and firmware upgrades and downgrades.
Use the following procedure to configure logical switches to use basic configuration values:
1. Connect to the physical chassis and log in using an account with the chassis-role permission.
2. Enter the configureChassis command to ensure that newly created logical switches have the
Fabric OS Administrator's Guide
53-1002745-02

Configuring logical switches to use basic configuration values

fosconfig --show
lscfg --config 128 -slot slot -port port
lscfg --delete fabricID
fosconfig --disable vf
switchA:FID128:admin> fosconfig --show
FC Routing service:
iSCSI service:
iSNS client service:
Virtual Fabric:
Ethernet Switch Service
switch:admin> fosconfig --disable vf
WARNING:
This is a disruptive operation that requires a reboot to take
effect.
Would you like to continue [Y/N] y
same basic configuration values as the default logical switch:
configurechassis
disabled
Service not supported on this Platform
Service not supported on this Platform
enabled
Service not supported on this Platform
10
291

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fabric os 7.1.0

Table of Contents