HP StoreFabric SN6500B Administrator's Manual page 408

14
Encryption and compression examples
Are you done? (yes, y, no, n): [no] y
Saving data to key store... Done.
myswitch:admin> secauthsecret --show
WWN
-----------------------------------------------
10:00:00:05:1e:e5:cb:00
myswitch:admin>
Activate authentication
After you set up the DH-CHAP secrets, you activate DH-CHAP authentication.
myswitch:admin> authutil --policy -sw active
Warning: Activating the authentication policy requires either DH-CHAP secrets or
PKI certificates depending on the protocol selected. Otherwise, ISLs will be
segmented during next E-port bring-up.
ARE YOU SURE
Auth Policy is set to ON
myswitch:admin> authutil --show
AUTH TYPE
--------------------------------------
dhchap
Switch Authentication Policy: ON
Device Authentication Policy: OFF
myswitch:admin>
Enabling encryption
Next, you enable encryption on port 0. Note that the first attempt fails because the port is currently
enabled. This example uses the portCfgShow command to check the result. Notice that the output
shows encryption to be enabled on the port.
myswitch:admin> portcfgencrypt --enable 0
Please disable port to configure Encryption/Compression.
myswitch:admin> portdisable 0
myswitch:admin> portcfgencrypt --enable 0
Turning ON Encryption on port(246) will cause the port to be disabled during next
LOGIN
myswitch:admin> portenable 0
myswitch:admin> portcfgshow 0
Area Number:
Octet Speed Combo:
Speed Level:
AL_PA Offset 13:
Trunk Port
Long Distance
VC Link Init
Locked L_Port
Locked G_Port
Disabled E_Port
Locked E_Port
ISL R_RDY Mode
RSCN Suppressed
Persistent Disable
LOS TOV enable
NPIV capability
QOS E_Port
Port Auto Disable:
408
DId
150
(yes, y, no, n): [no] y
HASH TYPE GROUP TYPE
md5 4
0
3(16G,10G)
AUTO(SW)
OFF
ON
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
ON
AE
OFF
Name
dcx_150
Fabric OS Administrator's Guide
53-1002745-02