Table 47 Cli Commands To Display Or Modify Switch Configuration Information - HP StoreFabric SN6500B Administrator's Manual

-all
If you must set up your switch again, run the commands listed in
file format. Store the files in a safe place for emergency reference.
TABLE 47
Command
configShow
fcLunQuery
fcrRouterPortCost
fcrXlateConfig
fosConfig
ipAddrShow
isnscCfg
licenseShow
portCfgEXPort
portCfgVEXPort
Fabric OS Administrator's Guide
53-1002745-02
The number of switches or FIDs defined in the downloaded configuration file
must match the number of switches or FIDs currently defined on the switch.
The switches must be disabled first. If they are not, the configDownload
command will download the configuration for as many switches as possible until
a non-disabled switch is found. If a non-disabled switch is found, the
downloading process stops. Before running the configDownload command, verify
if any switches must be disabled.
If you are performing a configuration download due to a configuration error, it is
highly recommended to run the configDefault command before running the
configDownload command. Refer to
switch" on page 248 for more information on non-disruptive configuration
downloads.
If Virtual Fabrics mode is enabled, the chassisDisable and chassisEnable
commands are used to disable all logical switches on the affected switch. This
process bypasses the need to disable and enable each switch individually once
the configuration download has completed.
Non-Virtual Fabric configuration files downloaded to a Virtual Fabric system have
a configuration applied only to the default switch. If there are multiple logical
switches created in a Virtual Fabric-enabled system, there may be problems if
there are ports that belong to the default switch in a Virtual Fabric-disabled
system, but are now assigned to logical switches in a Virtual Fabric-enabled
system. Only configurations related to ports within the default switch are applied.
CLI commands to display or modify switch configuration information
Displays
System configuration parameters, settings, and license information.
LUN IDs and LUNs for all accessible targets.
FC Router route information.
Translate (xlate) domain's domain ID for both EX_Port-attached fabric and backbone fabric.
Fabric OS features.
IP address.
Configuration state of the iSNS client operation.
License keys installed with more detail than the license information from the configShow
command.
EX_Port configuration parameters.
VEX_Port configuration parameters.
Configuration file restoration
"Configuration download without disabling a
Table 47 and save the output in a
8
247