Press - Yamaha RX-V667 Owner's Manual

@ NDMI2
[] SCENE
Numeric keys
_CODE SET
!_7iSOURCEiRECERVER
Enter a remote control code "2064" using
_Numeric keys. _2,1
Once the remote control code is registered successfully
_]$OURGEw'REGEmVER will blink twice.
Registration successful: blinks twice
Registration failed: blinks 6 times
• If the registration fails, repeat fiom step 2.
• In case of an external component with multiple remote
control codes, the other remote control codes may be
supported. Repeat fiom step 2 with the other remote
control codes.
To switch between BD player linked to
scene selections, press []SCENE and at the
same time press _HDMt2 and hold it for
approximately 3 seconds.
Then you can operate the external components by
switching the input source to HDMI2. or selecting
HDMI2 in the registered scene.
Same steps for operating other external components,
press []SCENE and at the same time press the input
source key selected in step 3 and hold it for
approximately 3 seconds.
Resetti#g a# remote co#tin1codes
Resetting all remote control codes for external
components to the initial factory settings.
Perform each of the following steps within 1 minute.
Settings will be automatically stopped if more than 1
minute passes since the last operation. To reset, repeat
from step 1.
1
Press _iCODE SET using a pointed object
such as the tip of a ballpoint pen.
blinks twice
Press _iSOURCE/RECEIVER on the remote
control.
#@ Enter "9981" using _Numeric keys.
Once the remote control code is reset successfully
_]SOURCE/RECEIVER
will blink twice.
Reset successful: blinks twice
Reset failed: blinks 6 times
If setup fails, repeat from step 1.
"{bJ _ : When you want Io regisler a remole control code Io fl_e
_TV control keys, enter the TV remote control code in step 4.
En
98