Yamaha RX-V667 Owner's Manual page 38

NOTE
If the following messages appear, resolve the problems that have
occurred and carry out the measurement process again.
• When a warning message is displayed before
measurement
The YPAO microphone is
not connected.
The headphones are
connected.
The settings of this unit
are protected.
Connect the YPAO
microphone to the YPAO
MIC jack on the front
panel.
Remove the headphones.
Set "Memory Guard" in
the Setup menu to "Oft"
• Error messages
The unit was not able to
find the front channel.
The unit was only able to
find one of side of the
surround channels.
The unit was only able to
find one of side of the
channels.
Only one surround back
speaker is connected and
only the right side
surround back channel
sound is detected.
The noise is too loud,
preventing accurate
nleasurelnents fronl
being taken.
Even though surround
left and right speakers are
not connected, only the
surround back speakers
are connected.
Check that the left and
right front speakers are
connected correctly.
Check that the left and
right surround speakers
are connected correctly.
Check that the left and
right presence speakers
are connected correctly.
When only one surround
back speaker is
connected, connect to the
left side (SINGLE)
terminal.
Measure again in quiet
surroundings. Turn off any
devices in the room that
may be emitting noise, or
place them flmher a'a, ay
from the YPAO
microphone.
When this message is
displayed, selecting
"PROCEED" will allow
you to continue measuring.
However, we recommend
resolving the problem and
measuring again, as
continuing measurement
without doing so will not
give accurate results.
When using surround back
speakers, connection of the
surround left/right
speakers is necessary.
The YPAO microphone
has been removed.
The YPAO microphone
could not distinguish a
test tone.
You have carried out an
operation that has
cancelled the measuring
process.
An internal error has
occurred.
While measuring, take
care not to touch the
YPAO microphone.
Check that the YPAO
microphone has been
installed correctly.
Check that each speaker
has been connected and
installed correctly.
The YPAO microphone
or the YPAO MIC jack
may be broken. Inquire at
the retailer where you
purchased this unit, or the
nearest Yamaha service
center.
Carry out the measuring
process again. Do not
operate this unit by, t_r
example, adjusting the
volume.
Carry out the measuring
process again. Contact a
Yamaha service center if
"E-10" is displayed
again.
En
38