Yamaha RX-V667 Owner's Manual page 141

1 To assure the finest perl\_rmance, please read this manual
carefully. Keep it in a safe place t\_r future reference.
2 Install this sound system in a well ventilated, cool, dry, clean
place - away from direct sunlight, heat sources, vibration, dust,
moisture, and/or cold. For proper ventilation, allow the following
minimum clearances.
Top: 30 cm, Rear: 20 cm, Sides: 20 cm
3 Locate this unit away from other electrical appliances, motors, or
transl\_rmers to avoid humming sounds.
4 Do not expose this unit to sudden temperature changes from cold
to hot, and do not locate this unit in an environment with high
humidity (i.e. a room with a humidifier) to prevent condensation
inside this unit, which may cause an electrical shock, tire,
damage to this unit, and/or personal injury.
5 Avoid installing this unit where foreign object may fall onto this
unit and/or this unit may be exposed to liquid dripping or
splashing. On the top of this unit, do not place:
- Other components, as they may cause damage and/or
discoloration on the surface of this unit.
- Burning objects (i.e. candles), as they may cause tire, damage
to this unit, and/or personal injury.
- Containers with liquid in them, as they may fall and liquid
may cause electrical shock to the user and/or damage to this
unit.
6 Do not cover this unit with a newspaper, tablecloth, curtain, etc.
in order not to obstruct heat radiation. If the temperature inside
this unit rises, it may cause tire, damage to this unit, and/or
personal injury.
7 Do not plug in this unit to a wall outlet until all connections are
complete.
8 Do not operate this unit upside-down. It may overheat, possibly
causing damage.
9 Do not use l\_rce on switches, knobs and/or cords.
10 When disconnecting the power cable from the wall outlet, grasp
the plug; do not pull the cable.
11 Do not clean this unit with chemical solvents; this might damage
the finish. Use a clean, dry cloth.
12 Only voltage specified on this unit must be used. Using this unit
with a higher voltage than specified is dangerous and may cause
fire, damage to this unit, and/or personal injury. Yamaha will not
be held responsible for any damage resulting from use of this unit
with a voltage other than specified.
13 To prevent damage by lightning, keep the power cable and
outdoor antennas disconnected from a wall outlet or this unit
during a lightning storm.
14 Do not attempt to modify or fix this unit. Contact qualified
Yamaha service personnel when any service is needed. The
cabinet should never be opened for any reasons.
15 When not planning to use this unit for long periods of time (i.e.
vacation), disconnect the AC power plug from the wall outlet.
16 Be sure to refer to the "Troubleshooting" section of the Owner's
Manual on the CD-ROM for common operating errors bel\_re
concluding that this unit is faulty.
17 Bel\_re moving this unit, press _ to set it to standby mode and
disconnect the AC power plug from the wall outlet.
18 VOLTAGE SELECTOR (Asia and General models only)
The VOLTAGE SELECTOR on the rear panel of this unit must
be set t\_r your local main voltage BEFORE plugging into the AC
wall outlet. Voltages are:
............... AC 110112012201230-240V,50160Hz (General model)
.................................. AC 2201230-240V_50160Hz (Asia model)
19 Condensation will l\_rm when the surrounding temperature
changes suddenly. Disconnect the power cable from the outlet,
then leave this unit alone.
20 When using this unit l\_r a long time, this unit may become warm.
Turn the power off, then leave this unit alone l\_r cooling.
21 Install this unit near the AC outlet and where the AC power plug
can be reached easily.
22 The batteries shall not be exposed to excessive heat such as
sunshine, fire or the like. When you dispose of batteries, tk_llow
your regional regulations.
23 Excessive sound pressure from earphones and headphones can
cause hearing loss.
24 When replacing the batteries, be sure to use batteries of the salne
type. Danger of explosion may happen if batteries are incorrectly
replaced.
This unit is not disconnected from the AC power source as
long as it is connected to the wall outlet, even if this unit itself
is turned offby _. This state is called the standby mode. In
this state, this unit is designed to consume a very small
quantity of power.
WARNING
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,
DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE.
This label is required to be attached to a product of which the
temperature of the top cover may hot during operation.
3 En