Yamaha RX-V667 Owner's Manual page 71

5
Make sure the Bluetooth component
recognizes the Bluetooth wireless audio
receiver.
When the device is recognized, it will appear in the
Bluetooth component list. for example as "YBA- 10
YAMAHA."
Select the Bluetooth wireless audio receiver
from the Bluetooth component list, and
enter a pass key "0000" into the Bluetooth
component. _51
When pairing occurs correctly
Using Bluetoothr " components
When pairing is complete, perform the following
procedure to achieve a wireless connection between this
unit and the Bluetooth component. When the wireless
connection is complete, Bluetooth components can be
played back.
Depending on Bluetooth components, a wireless
connection is established automatically or by
operating the Bluetooth components. In that case, it is
not necessary to carry out the following procedure.
Press _DOCK to switch to the DOCK input.
Press _OPTION to display the OPTION
menu.
@
Use _lCursor/_ / _7to select "Connect" and
press _IENTEFL _,2
When wireless connection is complete
"Not found" is displayed when there is an error
connecting. Check that the following conditions have
been satisfied, and try to establish a wireless
connection again.
• Both this unit and the Bluetooth component are paired.
• The Bluetooth component is switched on.
• The Bluetooth component is within 32 It. (10 m) of the
Bluetooth wireless audio receivm:
Operate the Bluetooth component for
playback.
To disconnect a wireless connection, repeat the same
steps, and in step 3, select "Disconnect."
@DOCK
[_Cumor_/v
_ENTER
_OPTION
"ibj_ : Depending on Bluetonth components, wireless connection is
carried nut right af]er the pairing. In this case, "BT connected" is
displayed instead of "Completed?'
"ibj2 : "Disconnect" is displayed when a Bluetonth component has been
connected.
En
71