Yamaha RX-V667 Owner's Manual page 112

!ii;iii!iiii! !i!i ;;iiiiiiiiiii iilC Li iil l ilili :ilili
Remote control
The Yamaha Bluetooth wireless
audio receiver and the Bluetooth
component are in the process of
pairing.
The Yamaha Bluetooth wireless
audio receiver and the Bluetooth
component are in the process of
establishing a connection.
The pairing is completed.
The pairing is canceled.
The connection between the
Yamaha Bluetooth wireless audio
receiver and the Bluetooth
component is established.
The Bluctooth component is
disconnected from the Yamaha
Bluetooth wireless audio receiver.
S,iii, ._ii_ i." ,:::.i_ J. i .%? . .....
C,:::, rq F:" ] . e "i:.. e ,::i
Ca i._ , :::. e :i. e ,::i
i!!!', T ,:::. ,:::,i._ iqe,:::..i:.. e ,::i
Ho "i:..f':"o u i"!_:::i
The Bluetooth component is not
found.
During pairing:
- pairing must be pert_rmed on the
Bluetooth component and this unit
simultaneously. Check if the Bluetooth
component is in pairing mode.
During connecting:
-check if the Bluetooth component is
turned on.
- check if the Bluetooth component is
within 10 m (32 feet) of the Yamaha
Bluetooth wireless audio receiver.
Pairing may not have been Try pairing again. 70
achieved.
See
Pr oblem i Cause Remedy page
The remote control
Wrong distance or angle.
does not work or
function properly.
Direct sunlight or lighting (from
an inverter type of fluorescent
lamp, strobe light, etc.) is striking
the remote control sensor of this
unit.
The batteries are weak. 7
The remote control ID of the 97
remote control and this unit do not
match.
External components The remote control code is not
The remote control will tunction within a
maxinmm range of 6 m / 20 ft, and no more
than 30 degrees off-axis from the front
panel.
Adjust the lighting angle, or reposition this
unit.
Replace all batteries.
Match the remote control ID of this unit and
the remote control.
Set the remote control code correctly using
"Remote control code search" on the CD-
ROM.
Try setting another code lUr the same
manufacturer using "Remote control code
search" on the CD-ROM.
If this unit does not work when you press
Cursor zX/ V / <3/ E>,do the following.
When the key does not work during DVD
disc menu operation: press the hput
selector again.
When there is no response with remote
control operation of the OPTION menu/
Setup menu: press SOURCE/RECE!VER
(it should glow orange) and try operating the
remote control again.
cannot be controlled
using the remote
control.
correctly set.
Even ifthe remote control code is
correctly set, there are some
models that do not respond to the
remote control.
En
112