Yamaha RX-V667 Owner's Manual page 37

_ENTER
_iRETuR.
See "Error messages" (_) for instructions on
resolving the problem and measure acoustics again.
Check the error code displayed and use YPAO to
measure acoustics again as described below.
When "E-1 ," "E-2," "E-a," "E-4" or "E-6" is
displayed
Press _IENTER.
Press _lCursor I> to select "EXIT."
#_ Press _ENTER to terminate YPAO, and
£_ switch the unit to standby mode.
Check that the speakers are properly
connected.
_P_ Turn on the unit and use YPAO again.
5
When "E-5," "E-7," "E-8" or "E-9" is displayed
Press _IENTER.
@
4
When "E-10" is displayed
Press _IENTER.
Press _lCursor I> to select "RETRY."
Press _IENTER to use YPAO again.
Press _lCursor I> to select "EXIT."
#_ Press _IENTER to terminate YPAO.
@
Switch the unit to standby mode.
_f_ Turn on the unit and use YPAO again.
5
See "Warning messages" (_) for instructions on
resolving the problem. The speaker causing the problem
can be confirmed from the TV screen display.
NOTE
Although the results of acoustics measurement can be
applied when a warning message is displayed, optimal
sound will not be achieved. Resolving the problem
and using YPAO to measure acoustics again is
recommended.
To exit YPAO with some options
Use _Cursor A ! _ to select "Save/Exit"
and press _]ENTER.
2
Use _Cursor q I > to select one of the
following options and press _]ENTER.
SAVE:
Exits YPAO applying the results of measurement.
CANCEL:
Returns to the previous screen (warning message
screen).
EXIT:
Exits YPAO without saving the results.
Check that the environment is suitable for
accurate measurement.
En
37