Yamaha RX-V667 Owner's Manual page 100

Avoiding crossing remote control
signals when using multiple
Yamahareceivers
The remote control of the unit can only receive signals
from a receiver which has an identical ID (remote
control ID). When using multiple Yamaha AV receivers,
you can set each remote control with a unique remote
control ID for its corresponding receiver.
On the contrary, if you are setting the same remote
control ID for all receivers, you can use one remote
control to operate 2 receivers.
Receives the remote control signals set in
IDl.
Receives the remote control signals set in
ID2.
ID1 is set for both remote control and receiver by
default. To avoid crossing remote control, change the
remote control ID for both remote control and
receiver.
• To change the remote control ID
Perform each of the following steps within
1 minute. Settings will be automatically stopped if
more than 1 minute passes since the last operation.
To reset, repeat from step I.
Press 1i"?]80 U RCE/R EC EJVEF{.
Enter the desired remote control ID code.
To switch to ID1 :
Enter "5019" using _i_lNumeri¢ keys.
To switch to ID2:
Enter "5020" using [_i_jNumeric keys.
Once the remote control code isregistered successfitlb
I]2]SOUFICE/RECEIVERwill blink twice.
Registration successful: blinks twice
Registration failed: blinks 6 times
Resetting the SIRIUS SateN#e
Radior_ parental lock cede
Reset the SIRIUS Satellite Radio parental lock code to
the factory default setting.
Resets the code to the factory default
setting.
Cancels resetting of the parental lock
code.
Numeric keys
CODE SET
!_i SOURCE/RECEIVER
• If setup fails, repeat fi'om step I.
• Returns to [DI after the remote control code is
initialized _,'_l 2. 98).
En
1O0