Yamaha RX-V667 Owner's Manual page 34

Connect the YPAO microphone to the YPAO
MIC jack on the front panel.
This completes preparation. To achieve more accurate
results, take note of the following when measuring
acoustics.
• It takes approximately 3 minutes to accurately
measure acoustics. Keep the room as quiet as possible
while acoustics are measured.
• Wait in a corner of the room. or leave it entirely, while
acoustics are measured to avoid creating an
obstruction between the speakers and the YPAO
microphone.
Display during measurement
"Mic O11.View ON SCREEN" appears oll the hont
panel display, and the following display appears oll the
fiont panel display o] TV screen.
5
Press _Cursor _ / _7 repeatedly to select
the "Measure" and press _IENTER to start
measurement.
Auto measurement starts in 10 seconds.
To start the measurement immediately, press
_]ENTER again.
To cancel the automatic setup and return to the
previous screen, press _iRETURN and then
_iENTER.
The following display appears when measurement
finishes without any problems.
[_ Cursor _/v
[_ ENTER
_iRETum_
En
34