Yamaha RX-V667 Owner's Manual page 89

Sets the initial volume for when this receiver is turned on. When
this parameter is set to "Off," the volume is set at the level when the
receiver last entered standby mode. _3>_
off, Mute, -80 dB to +16.5 dB
off
0.5 dB
Ad ust ng ©SP effect and vo _ _'_e eve
Automatically adjust the level of DSP effect in conjunction with
the volume level.
Disables autonmtic adjustment of the level of DSP
effect.
Adjusts the degree of DSP effect in conjunction with
volume level. The higher the volume level, the less the
DSP effect applied. The lower the volume level, the
greater the DSP effect applied.
Settingthis unit's videoou@utfunction
Video Setup items
Enable or disable video conversion between analog
video jacks.
Enable or disable adjustment of resolution and aspect
ratio for video signal converted to HDMI video.
Enables or disables video conversion between analog video jacks.
Disables video conversion between analog video
acks.
Enables video conversion between analog video jacks.
• Analog-to-HDM[ video conversion is always possible unless
video signals are being input at the HDMI input jacks or 1080p-
resolution analog video signals are being input (_,__p. 1 15).
• This unit does not convert 480 line video signals and 576 line
video signals interchangeably.
• 480p-, 576p-, 1080i- and 720p-resolution video signals can not
be output at the VIDEO MONITOR OUT jack (_. 115).
• The converted video signals are only output at the MONITOR
OUT
jacks.
• When composite video signals from a VCR are converted into
component video signals, the picture quality may suffer
depending on your VCR.
• Unconventional signals input at the composite video jacks cannot
be converted or may be output abnormally. In such cases, set
"Analog to Analog Conversion" to "Off."
"ibj_ : When you set "Max Volume" at a lower level than "Initial Volume," "Max
Volume" has priority.
En
89