Disabling Secure Mode - HP StorageWorks MSA 2/8 - SAN Switch User Manual

Disabling Secure Mode

Secure Mode is enabled and disabled on a fabric-wide basis, and can be enabled
and disabled as often as desired. However, all Secure Fabric OS policies,
including the FCS policy, are deleted each time Secure Mode is disabled, and
must be re-created the next time it is enabled. The policies can be backed up using
the configupload and configdownload commands. For more
information about these commands, refer to the HP StorageWorks Fabric OS
Version 3.1.x/4.1.x Reference Guide.
You can disable Secure Mode only through a sectelnet, SSH, or serial connection
to the Primary FCS switch. When Secure Mode is disabled, all current login
sessions are automatically terminated.
For information about re-enabling Secure Mode, see
page 49.
1. From a sectelnet, SSH, or serial session, log into the Primary FCS switch as
2. Enter secmodedisable.
3. Enter the password when prompted.
4. Enter y to verify that you want to disable Secure Mode on the fabric.
5. Secure Mode is disabled, all current login sessions are terminated, and the
Secure Fabric OS Version 1.0 User Guide
Admin.
passwords are modified as follows:
On the switches that were FCS switches: The User, Admin, Factory, and
Root passwords remain the same as in Secure Mode.
On the switches that were Non-FCS switches: The Root, Factory, and
Admin passwords become the same as the Admin password on the
switches that were FCS switches.
Removing Secure Fabric OS Capability
"Enabling Secure Mode" on
123