Table of Contents
Advertisement
Static VLAN Configuration Screen
7.3.4
Deleting a Static VLAN
To delete a VLAN from the VLAN list, proceed as follows:
1. Use the arrow keys to highlight the line containing the
information.
The following message is displayed at the top of the screen:
"Hit <RETURN> key to edit port list, or <M> to mark."
NOTE: The default VLAN cannot be deleted from the list.
2. Press the M (not case sensitive) key, and an asterisk (*) appears to the left of the highlighted line.
If more than one VLAN is to be deleted, repeat steps 1 and 2 to highlight and mark each line.
Otherwise, go to step 4.
NOTE: If for some reason you want to remove a mark, perform steps 1 and 2 to mark
the line. Then press M to delete the mark.
3. After the lines are marked, use the arrow keys to highlight the DEL MARKED command.
4. Press ENTER. The VLANs and marked line items are deleted from the list.
7.3.5
Paging Through the VLAN List
To display additional VLANs that do not display in the current VLAN List as shown on the screen,
use the NEXT or PREVIOUS commands located at the bottom of the screen, as follows:
NOTE: The NEXT and PREVIOUS fields will only display if there are further VLAN List
entries to page through.
1. To display the next screen, use the arrow keys to highlight NEXT. Press ENTER to view the
entries on the next screen.
2. To display the previous screen, use the arrow keys to highlight PREVIOUS. Press ENTER to
view the entries on the previous screen.
7-10
802.1Q VLAN Configuration Menu Screens
VLAN ID, FDB ID, and VLAN Name
Advertisement
Table of Contents
