Table of Contents
Advertisement
Table 8-10 Rate Limiting Configuration Screen Field Descriptions (Continued)
Use this field...
Max Rate: kbps
(Modifiable)
ADD
(Command)
DEL ALL/DEL
MARKED
(Toggle)
8.8.1
Configuring a Port
The following describes how to configure a port using the Rate Limiting Configuration screen:
1. To enter a Port Type, proceed to
a. Use the arrow keys to highlight the field (1) below the Port Number field.
b. Type in the port number and press ENTER.
c. Proceed to
step
To...
Enter the maximum transmission rate for this entry. The maximum
transmission rate includes all frames associated with the priorities
selected in the Priority List field. The default is the high setting of
100 Kbps maximum interface speed. The high range setting is 100
Kpbs to 1 Gbps. The low range setting is 50 to 40000 Kpbs.
For details on rate limiting, refer to
NOTE: For further details on configuring the rate limiting range
on a port, refer to the rate_limit_mode command in
Section
11.2.
Add the current port, priority, and maximum rate selections to the
screen. For details about how to configure and add an entry, refer to
Section
8.8.1.
Delete all or one or more marked entries. The DEL ALL command is
the default and it is used to simultaneously delete all the lines of
configured information. The DEL MARKED command appears in
place of the DEL ALL command when one or more lines are marked
for deletion. For details on using the two commands, refer to
Section
8.8.2.
step
2. To enter a port number, proceed as follows:
3.
Rate Limiting Configuration Screen
Section
8.8.1.
802.1p Configuration Menu Screens
8-41
Advertisement
Table of Contents
