Enterasys SmartSwitch 2200 Series 2E253 User Manual page 318

Built-in Commands
radius (Continued)
Examples:
(Cont'd)
rate_limit_mode
Description:
Syntax:
Options:
11-26 Network Tools Screens
NOTE: The following shows examples of when 3, 7, and 32
characters are entered as the secret code (16 to 32 characters are
recommended).
-> radius sec_secret
Enter Secret (max 32): ***
Confirm Secret: ***
# ERROR : secret minimum length is 6
-> radius sec_secret
Enter Secret (max 32): *******
Confirm Secret: *******
Warning: rfc2865 recommends min length of 16
ok
-> radius sec_secret
Enter Secret (max 32): ********************************
Confirm Secret: ********************************
ok
Displays the status of rate limiting or configures the exit-rate limit range to
either the default high_range (100 Kbps to 1 Gbps) or the low range (50 Kbps
to 400 Mbps). This mode is stored in non-volatile memory and is retained by
normal resetting. Changing from one mode to the other mode may result in
current settings being removed if their range is no longer valid. Changing rate
limit mode will require a reset.
rate_limit_mode [ status ] [ high_range (default) ] [ low_range ]
status — Displays rate limiting status.
high_range — Sets the default rate limit high range.
low_range — Sets the default rate limit low range.