Igmp/Vlan Configuration Procedure - Enterasys SmartSwitch 2200 Series 2E253 User Manual

Table 9-2 IGMP/VLAN Configuration Screen Field Descriptions (Continued)
Use this field...
VLAN ID
(Modifiable)
IGMP State
(Selectable)
9.2.1

IGMP/VLAN Configuration Procedure

To set up IGMP protocol for VLANs, proceed as follows:
1. Use the arrow keys to highlight the VLAN ID field, and use the SPACE bar to step through the
VLAN choices to find the correct VLAN to configure.
NOTE: The VLAN IDs are those of the VLANs created using the Static VLAN
Configuration screen described in
However, a VLAN ID of a VLAN not yet created can be entered, and the parameters can
be configured and saved using the SAVE command. However, the VLAN and its
configuration is not functional until that VLAN is created using the Static VLAN
Configuration screen. Parameters not modified default according to the MIB.
2. Use the arrow keys to highlight the IGMP State field.
3. Use the SPACE bar to select ENABLED, DISABLED, or DELETE. If a specific VLAN was
chosen in Step 1, ENABLED and DISABLED are used to enable or disable the IGMP
To...
Enter the Identifying number of the VLAN to be modified. If there are
no VLANs configured for IGMP, NONE is displayed in this field and
asterisks (*) will display in the Configuration, Statistics, and IGMP
State fields. The information under Configuration and Statistics applies
only to this VLAN ID. Use the SPACE bar to step through all available
VLAN IDs.
The fields that are selectable or modifiable will initially display
asterisks (*), then the SPACE bar can be used to display the selectable
fields, and the numeric keys can be used to change the modifiable
fields.
To update the Configuration and Statistics fields for a selected
VLAN ID, use the SAVE command.
See the current state of the VLAN indicated in the VLAN ID field,
which can be modified. Use the SPACE bar to step through the choices:
ENABLED, DISABLED, and DELETE. The commands will act only
on the VLAN whose ID is in the VLAN ID field.
Chapter
IGMP/VLAN Configuration Screen
8.
Layer 3 Extensions Menu Screens 9-7