Clear Port Mirroring; Set Mirror Vlan - Enterasys C3G124-24 Configuration Manual

Usage
LAG ports, as described in
mirror source ports. However, if a LAG port is configured as the source port, no other ports can be
added as source ports for that mirror.
Examples
This example shows how to create and enable port mirroring with ge.1.4 as the source port, and
ge.1.11 as the target port:
C3(su)->set port mirroring create
This example enables a mirror that was previously disabled.
C3(su)->set port mirroring enable

clear port mirroring

Use this command to clear a port mirroring relationship.
Syntax
clear port mirroring source destination
Parameters
source
destination
Defaults
None.
Mode
Switch command, read-write.
Example
This example shows how to clear a port mirroring relationship between source port ge.1.4 and
target port ge.1.11:
C3(su)->clear port mirroring

set mirror vlan

Assigns a VLAN to be reserved for mirroring. If a mirrored VLAN is created, all mirrored traffic
will egress VLAN tagged. All traffic on the mirror VLAN will be flooded.
Syntax
set mirror vlan vlan-id
"Link Aggregation Control Protocol
ge.
1.4
ge.
1.4
Specifies the source ports (up to 8 ports) of the mirroring configuration to
be cleared. For a detailed description of possible port-string values, refer to
"Port String Syntax Used in the
Specifies the target port of the mirroring configuration to be cleared.
ge. ge.
1.4 1.11
(LACP)" on page 11-44, can be
ge.
1.11
ge.
1.11
CLI" on page 11-1.
Enterasys C3 Configuration Guide 11-41
clear port mirroring