Setting The Message Storage - Brother IntelliFAX 1350M Owner's Manual

GETTING STARTED MESSAGE CENTER MODE SETTINGS
The 3 Basic Steps to Turn the Message Center Mode On
You can get started receiving messages by doing the following three steps.
1. Setting the Message Storage.
2. Recording the Outgoing Message (MSG CTR OGM).
3. Activating the Message Center Mode.
Setting the Message Storage
Setting the Message Storage is the first step in turning on the Message Center Mode.
Before you set the Message Storage, make sure you carefully read the "Mode Settings at a Glance"
(see page 11-2). If you are using the Voice-on-Demand option, it is a good idea to set TAD mode
to ON. Then, if a caller does not enter a command during the Message Center Pro OGM, the
caller's message will still be stored in the flexible memory for TAD messages. Once you decide the
mode that best suits your needs, follow the steps below.
1. Press FUNCTION.
2. Press 8.
3. Press 1.
4. Press -_ (left arrow) or m,- (right
arrow) repeatedly to select ON or
OFF.
Example: FAX: ON.
5. Press SET.
6. Press ---I (left arrow) or _ (right
arrow) repeatedly to select ON or
OFF.
Example: TAD: ON.
7. Press SET.
8. Press STOP to exit.
m mr," -' l nO A
( 1.TEMP.SETTINGS )
( 8.SETUP MSG CTR )
[ 1.MSG STORAGE ]
FAx: O FF ] (
-( SELECT ,- -, SET)
(
FAX:ON ]
_( TAD:ON ]
SELECT <---'>& SET
(TAD:ON ]
1.MSG STORAGE ]