Brother IntelliFAX 1350M Owner's Manual page 105

REMOTE FAX OPTIONS
Remote Control Commands
You can control your fax machine with the following remote control commands.
Detail Operation Remote control command
95
96
97
98
Changing Fax Forwarding
/Paging setting
1 OFF
2 Fax Forwarding
3 Paging
4 FAX FWD No.
5 FWD No. Confirm
6 Fax Storage ON
7 Fax Storage OFF
Retrieve FAX
1 Memory Status List
2 00 Retrieve all FAXES
2 "MSG No." 00
Retrieve by MSG
number
3 Erase FAX in the
memory
Check the receiving status
1 FAX
Change Answer Mode
1 TAD
2 F]T
3 AUTO
If you hear one long beep, the change is accepted. If you hear three
short beeps, you can not change it because the conditions (ex.
registering fax forwarding or paging number) have not been
completed. You can register your fax forwarding number by using
4. FAX FWD No. (see page 10-8). Once you have registered the
number, the machine will automatically turn to "FAX FWD:ON"
mode. Then, receive a Memory Status List by entering 961 (see page
10-8). Check the List to make sure the Fax Forwarding number you
registered is correct. Then enter the confirmation command 955.
Now the machine will start Fax Forwarding.
You can set FAX STORAGE ON or OFF.
You can use a remote fax machine to receive a List or stored fax
message(s). (See page 10-8.)
If you hear one long beep, you can erase fax message(s) from the
memory.
You can check whether your fax machine has received any fax
message(s). If yes, you will hear one long beep. If no, you will hear
three short beeps.
If you hear one long beep, you can change the Answer Mode. If you
hear three short beeps, you can not change it.
90 Exit After a long beep, you can exit remote control.
Printing a Fax Message
You can print a fax message that is stored in the memory.
mi'.14.]_,1_lr,_¥'A,,Vtll_!":[e]hv
1. Press
FUNCTION.
2. Press
8.
3. Press
4.
4. Press START.
5. Press STOP to exit.
( FAX IN MEMORY:03 )
(
I.TEMP.SETTINGS
)
( 8.REMOTE FAX OPT ]
( 4.PRINT FAX ]
( PRESS START KEY 1
(
PRINTING
)
( 4.PRINT
FAX
)
1 I m Ill _1 I
10-7