Brother IntelliFAX 1350M Owner's Manual page 126

MESSAGE CENTER MODE SETTINGS REMOTE RETRIEVAL
Setting the Remote Access Code
Use the Remote Access Code from another location to retrieve voice and/or fax messages that are
stored in your Message Center's memory. Change your Remote Access Code and use it as a "secret
password" if you wish to safeguard your messages.
The factory default setting for the Remote Access Code is "159_<". You can change the first three
digits of the Remote Access Code, but the last digit (an asterisk) can not be changed. The first three
digits must not be the same as your Remote Activation or Remote Deactivation Codes. (Example:
If your Remote Access Code is 160_<, do not use 160, 60>k, 01>k, 02* or 03>k for either the Activation
or Deactivation Code.) When you use the Remote Access Code, you must press all four keys (three-
digit number plush<)
1. Press FUNCTION.
2. Press 8.
3. Press
4.
4. Enter a three digit number 000 to
999. The last digit, an asterisk, can
not be changed.
Example: 160..
5. Wait for two seconds.
6. Press STOP to exit.
m I"1:1D] F ']d7;Y&v;_Iqqi,-]" [ ely;him
09/12/1996 15:25 )
( I.TEMP.SETTINGS )
8.SETUP MSG CTR )
4.REMOTE ACCESS
ACCESS CODE:159_
( ACCESS CODE:160_
( 4. REMOTE ACCESS
Helpful Hints
Change the remote control code and use it as a "'secret password" to limit access
to your Message Center.
When you use the Remote Access Code, you must press all four keys (three-digit
number plus _<).
11-20