Setting The Ip Address And Network Mask Of Your Computer For Direct Connection - Gerber EDGE FX Owner's Manual

9 Press F1, NETWORK to display the NETWORK MENU.
10 Press F1, TCP/IP to display the TCP/IP MENU where you can change the Subnet
Mask of the GERBER EDGE FX.
11 Press F2, SUBNET MASK to open the SUBNET MASK MENU where you can change
the Subnet mask of the printer. The
changed. Use F4, NEXT to move the active designation to the octet you wish to update.
12 Use the Left or Right Slew keys to change the value of the octet. Press F4, NEXT to
move the active designation to the next octet and change that value. Continue until the
entire Subnet Mask is updated.
13 Press F1, SAVE to set the displayed Subnet Mask. The display changes to:
used after reboot.
14 Press F3, CANCEL to exit the menu and return to the MAIN MENU.
15 Cycle the power to the GERBER EDGE FX. The network address will be active after
cycling the printer power.
Setting the IP Address and Network Mask of your computer for direct
connection
If you need to change the network address of you computer that is directly connected to the
GERBER EDGE FX, follow the procedure for your Windows operating system (Windows 98 SE
(with Internet Explorer 5.5 or higher), Windows XP, or Windows 2000). These procedures use
the following address for the computer:
♦ Computer IP address: 169.254.128.130
♦ Computer Network Mask: 255.255.0.0
NETWORK MENU
F1 TCP/IP
F2 ETHERNET
TCP/IP MENU
F1 IP ADDR.
F2 SUBNET MASK
designates which octet is available to be
–––
SUBNET MASK MENU
F1 SAVE
F2 –––
255 . 255 . 000 . 000
CANCEL F3
F4
CANCEL F3
DHCP F4
CANCEL F3
NEXT F4
13
Subnet Mask