Installing The Gerber Edge Fx In Omega Software - Gerber EDGE FX Owner's Manual

Installing the GERBER EDGE FX in OMEGA software

The GERBER EDGE FX printer is compatible with OMEGA 2.1 or higher. Install the GERBER
EDGE FX using the Network tab of the Add or Delete Gerber Vinyl Printer dialog box in
GSPTray.
Note: If you are replacing an existing GERBER EDGE FX with a new one, you must first
uninstall the original printer using the Delete button in the Add or Delete Gerber Vinyl
Printer dialog box. Once the original printer is removed you can install the new GERBER
EDGE FX using the following procedure.
To install the GERBER EDGE FX using GSPTray
1 Right-click the GSPTray icon to open the GSPTray menu.
2 Click Install Vinyl Printer to open the Add or Delete Gerber Vinyl Printer(s) dialog
box.
3 Click the Network tab.
4 If the GERBER EDGE FX is visible on the network it is shown in the Devices Found
drop down list. Choose the printer to install from the list.
OR
Click the Browse button to navigate to the printer location.
OR
Type the IP number of your GERBER EDGE FX in the IP Address box. Refer to your
network administrator and "Connecting the GERBER EDGE FX to your computer" for
information on obtaining this address.
Tip: When the GERBER EDGE FX is located on the network it displays in the Devices Found
box. The first 12-digit number is the printer's MAC address (00-30-2D-C2-50-00 in the above
example), followed by the IP address (169.254.128.129 in the above example). The MAC address
is unique to that printer and cannot be changed.
25