Gerber EDGE FX Owner's Manual page 86

80 CHAPTER 7
Troubleshooting
Viewing the System Log
The System Log records information and error messages sent from the GERBER EDGE FX. You
can modify the System Log Level from 1 (lowest) to 9 (highest) using the System Settings web
page. The default setting is 1 (lowest) which records only the major errors and should be
adequate for most users. The highest setting records all messages sent to the GERBER EDGE FX
and is used by Gerber Technical Support for diagnostics. When the System Log is turned off (set
to 0 (OFF)) no messages are recorded.
The numbers in the brackets to the left of the message indicate the time the message was logged
since the printer was powered on. The time is displayed in
The System Log can contain up to 32 kb of text messages. When the log becomes full, the newest
message replaces the oldest message in the log.
To view the System Log
1 Open the GERBER EDGE FX web interface by entering the printer's IP address in the
Location or Address line of your web browser (for example: http://169.254.128.129).
The Welcome to GERBER EDGE FX screen displays.
2 Click the Diagnostics link to open the GERBER EDGE FX Diagnostics page.
3 Click the View Log link to open the EDGE FX Message Log page.
4 Click Home to return to the Welcome to GERBER EDGE FX page.
[hours : minutes : seconds : milliseconds]
.