Pausing And Restarting A Job; Canceling A Job - Gerber EDGE FX Owner's Manual

2 Press F4, MOTION to open the MOTION MENU.
3 Press and hold F1, FOIL to advance the foil from the supply roll to the take-up roll to
expose a new section of the foil.
4
Press F3, CANCEL to return to the MAIN MENU.

Pausing and restarting a job

Pressing F1, ONLINE while the job is printing pauses the job. When the job is paused you can
slew the material. Press F1, ONLINE again when a job is paused to restart the job at the same
location at which printing stopped.
Tip: To ensure correct registration when printing is paused and resumed, the GERBER EDGE
FX is set to overlap the foil at the position where the job was interrupted. The default amount
of overlap is 15 pixels. You may adjust the overlap to between 5 and 25 pixels. See "Changing
the overlap setting" on page 51.

Canceling a job

From the MAIN MENU, press F3, CANCEL on the control panel to stop the job and clear it
from the printer.
The GERBER EDGE FX displays a confirmation menu. Press F1, YES to cancel the job, or F3, NO
to return to the previous menu.
SYSTEM MENU
F1 NETWORK
F2 DIAG
MOTION MENU
F1 FOIL
F2
MAIN MENU
F1 ONLINE
F2 Mode: Single
CANCEL JOB?
F1 YES
F2
CANCEL F3
MOTION F4
CANCEL F3
HOME F4
CANCEL F3
SYSYEM F4
NO F3
F4
45