Substituting A Different Material - Gerber EDGE FX Owner's Manual

9 Carefully close the GERBER EDGE FX cover. Do not to slam the cover shut.
CAUTION: Slamming the cover shut can cause damage to the print head. Always
close the cover carefully.
10 On the MATERIAL MENU press F1, OK to confirm that the correct material is loaded.
11 The FOIL MENU requests the first foil needed for the job. See "Loading a foil cartridge
into the GERBER EDGE FX" on page 42 for additional instructions.

Substituting a different material

It is very important to use the material that has been designated for that job. Each material has
specific print settings assigned that ensure good foil adhesion. Failure to use the correct
material will result in incorrect print settings for the material actually being used.
You can choose a different material when designing the job in OMEGA, before outputting the
job in GSPPlot, or at the GERBER EDGE FX before printing begins. See the OMEGA Reference
Manual or Help for instructions on substituting materials in OMEGA or GSPPlot.
To substitute a material at the GERBER EDGE FX
1 After receiving a job the GERBER EDGE FX displays MATERIAL MENU. The material
designated for the job displays on the bottom line of the menu.
2 Press F2, SUBSTITUTE to choose a different material and display the MATERIAL
SUBST. MENU.
3 Press the F2, PREV or F4, NEXT (or the left and right slew keys) to scroll through the
list of available material. The substrates are numbered as shown in brackets [1].
4 When the desired material displays, press F2, OK to confirm the material selection. A
confirmation message displays.
MATERIAL MENU
F1 OK
F2 SUBSTITUTE
Need: 220
MATERIAL MENU
F1 OK
F2 SUBSTITUTE
Need: 225
MATERIAL SUBST. MENU
F1 OK
F2 PREV
Subst: [1] 220
CANCEL F3
MOTION F4
CANCEL F3
MOTION F4
CANCEL F3
NEXT F4
41