Gerber EDGE FX Owner's Manual page 29

3 Press F1, NETWORK to display the NETWORK MENU.
4 Press F1, TCP/IP to open the TCP/IP MENU.
5 Press F4, DHCP to open the DHCP menu.
6 Press F1, Enable to activate DHCP. The new setting will be in effect after cycling the
power to the printer. The system displays the following message:
7 Cycle the printer power to change the DHCP setting.
Note: If you have enabled DHCP and the server successfully assigns an IP address, you will no
longer be able to assign a static network address in the IP Address menu. If you return to the
IP Address menu the --- symbol that designates the ability to change the address no longer
appears. The lack of the --- symbol indicates that DHCP is enabled. You can disable DHCP if
you later need to use a static IP address.
NETWORK MENU
F1 TCP/IP
F2 ETHERNET
TCP/IP MENU
F1 IP ADDRESS
F2 SUBNET MASK
DHCP MENU
F1 ENABLE
F2 DISABLE
Currently Disabled.
F1 DHCP enabled after
F2 reboot.
CANCEL F3
F4
CANCEL F3
DHCP F4
CANCEL F3
F4
F3
F4
23