Viewing Gerber Edge Fx Version Menus - Gerber EDGE FX Owner's Manual

70 CHAPTER 7
Troubleshooting
To test network throughput
1 From the MAIN MENU press F4, SYSTEM to open the SYSTEM MENU.
2 Press F2, DIAG to open the DIAGNOSTIC MENU.
3 Press F2, NETWORK to open the NETWORK TEST MENU.
4 Send a job from OMEGA and the NETWORK TEST MENU monitors the throughput
rate and displays the results. The job data is discarded.

Viewing GERBER EDGE FX version menus

When troubleshooting the GERBER EDGE FX, it may be helpful to determine the versions of
firmware components. The easiest way to view the versions is through the DIAGNOSTICS page
of the web interface. See "Using the Diagnostics page" on page 71. You can also access version
information from the printer's control panel. The EDGE FX VERSION menus one through nine
display version information about the following firmware components:
♦ Release (1 of 9)
♦ Application (2 of 9)
♦ BootStrap (3 of 9)
♦ BootLoader (4 of 9)
♦ Language (5 of 9)
♦ FPGA (6 of 9)
♦ History (7 of 9)
♦ Fire File (8 of 9)
♦ RFID (9 of 9)
SYSTEM MENU
F1 NETWORK
F2 DIAG
DIAGNOSTIC MENU
F1 TEST PRINT
F2 NETWORK
NETWORK TEST MENU
F1
F2 Quality: Excellent
Rate: 600 kbytes/sec
CANCEL F3
MOTION F4
CANCEL F3
VERSION F4
CANCEL F3
F4