Chapter 6: Configuring The Gerber Edge Fx Via The Web Interface - Gerber EDGE FX Owner's Manual

Hide thumbs Also See for EDGE FX:

Table of Contents

Chapter 6:

Configuring the GERBER EDGE FX via the Web

Interface

The GERBER EDGE FX has a web interface that allows you access to the printer via a web

browser on any computer connected to it via a network or through direct connection. The web

interface address is the same as the GERBER EDGE FX IP address, for example:

http:// 169.254.128.129.

Note: When the GERBER EDGE FX ships from the factory, the default IP address is

169.254.128.129. The IP address may change during installation (and is different for each

printer when there are multiple printers at one location). To access the web interface, use the

current IP address assigned to that printer.

Through the web interface you can perform the following functions without using the GERBER

EDGE FX control panel:

♦ Check job status

♦ Change system settings such as overlap, language, or printer name

♦ Enter or change network addresses of the printer

♦ Perform system diagnostics

♦ Perform a firmware update

♦ View Gerber contact information

Tip: You may find it helpful to create a shortcut to the GERBER EDGE FX web interface on

your computer's desktop for quick access.

Table of Contents

Show Quick Links

Table of Contents