Changing The System Log Level - Gerber EDGE FX Owner's Manual

50 CHAPTER 6
Configuring the GERBER EDGE FX via the Web Interface

Changing the System Log Level

The System Log is an application running on the network that records messages sent from the
GERBER EDGE FX. You can view the System Log messages through the Diagnostics web page.
See "Viewing the System Log" on page 80 for details on viewing the log.
You can modify the System Log Level from 1 (lowest) to 9 (highest) using the web interface. The
lowest setting records only the major errors, and the highest records all messages sent from the
GERBER EDGE FX. Alternately, you can turn off the System Log completely. The default
System Log Level setting is 1 (lowest) and should be adequate for normal operation. Higher
settings may be requested by Gerber Technical Support for diagnostic purposes.
To change the System Log Level
1 Open the GERBER EDGE FX web interface by entering the printer's IP address in the
Location or Address line of your web browser (for example: http://169.254.128.129).
The Welcome to GERBER EDGE FX screen displays.
2 Click the System Settings link to open the System Settings page.
3 Choose a System Log Level between 1 (lowest) to 9 (highest) from the drop down list.
4 Choose 0 (OFF) if you wish to turn off the System Log.
5 Click Change Settings to apply the new System Log Level setting to the GERBER
EDGE FX.