Replacing Fuses - Gerber EDGE FX Owner's Manual

90 CHAPTER 8
Maintenance

Replacing fuses

WARNING: To avoid electric shock, perform all maintenance procedures with the
GERBER EDGE FX turned off and unplugged from the power source.
Two spare power-entry fuses (slow-blow) are provided with the GERBER EDGE FX. If you
need to replace one, locate the fuse carrier plate on the back panel of the printer as shown in the
following illustration. The fuse rating (amperage and voltage) is labeled next to the fuse carrier
plate.
Fuse carrier plate
WARNING: Double Pole/Neutral Fusing.
To replace a fuse
1 Unplug the printer and remove the power cord from the GERBER EDGE FX.
2 Insert a small flat screwdriver into the notch from below and gently pry the fuse
carrier plate out.
3 Remove the blown out fuse(s) from the carrier and insert new fuse(s).
4 Insert the fuse carrier into the GERBER EDGE FX with the notch down and snap into
place.
5 Reconnect the power cord.