Substituting A Different Foil; Advancing (Slewing) The Foil - Gerber EDGE FX Owner's Manual

44 CHAPTER 5
Operating the GERBER EDGE FX
8 If the printer is in Continuous mode it automatically begins printing. When in Single
mode, press F1, OK to confirm that the correct foil is loaded and to start printing.
9 After the GERBER EDGE FX prints the first color it rewinds the material and prompts
for the next foil required for the job. Insert the next foil cartridge and press F1, OK to
continue printing if in Single mode. (Printing continues automatically when in
Continuous mode.) The GERBER EDGE FX cycles through all of the foils required for
the job and displays the MAIN MENU upon completion.
Note: Depending on the Mode chosen (Continuous or Single) the GERBER EDGE FX either
remains Online and immediately continues with the next job (Cont.), or returns to the Offline
status (Single).

Substituting a different foil

If you do not have the foil originally designated in a job, you may substitute a different foil at
the time of printing.
To substitute a different foil
1 During printing the FOIL MENU appears to request the next foil required for printing.
2 If you do not have the requested foil, insert the foil you wish to use and press F1, OK.
The Substitution confirmation prompt displays.
3 Press F2, ACCEPT to confirm the selection and continue printing with the same foil.

Advancing (slewing) the foil

If the foil is dirty or has scratches you can advance (slew) the foil from the supply roll to the
take-up roll to expose an unused area of the foil. The FOIL command is located in the MOTION
MENU which is accessible from the SYSTEM MENU, MATERIAL MENU, and FOIL MENU.
This procedure uses the SYSTEM MENU to access the MOTION MENU.
To advance (slew) the foil
1 From the MAIN MENU press F4, SYSTEM to open the SYSTEM MENU.
FOIL MENU
F1 OK
F2
Need ProcPro Cyan
Substituting Foil !
F1
F2 ACCEPT
CANCEL F3
MOTION F4
CANCEL F3
F4