Diagnosing Printer Problems; Printing The Internal Test Print - Gerber EDGE FX Owner's Manual

68 CHAPTER 7
Troubleshooting
Substrate enabled
Prompts??
Foil enabled
Prompts??

Diagnosing printer problems

The DIAGNOSTIC MENU of the GERBER EDGE FX provides a small test print to verify that
the printer is capable of printing and a network test to determine the network throughput. From
the DIAGNOSTIC MENU you can also view the firmware version information which you may
need if speaking with Gerber technical representatives.
More diagnostic tools are available in the GERBER EDGE FX web interface. See "Using the
Diagnostic web page" on page 71.

Printing the internal test print

The internal test print is a simple print (shown in the following illustration) which uses Spot
Black foil (GSC-012) on white 3M Scotchcal Series 220 Premium Film.
To print the internal test print
1 From the MAIN MENU press F4, SYSTEM to open the SYSTEM MENU.
2 Press F2, DIAG to open the DIAGNOSTIC MENU.
enabled
disabled
enabled
disabled
SYSTEM MENU
F1 NETWORK
F2 DIAG
DIAGNOSTIC MENU
F1 TEST PRINT
F2 NETWORK
If enabled then GERBER EDGE FX waits for
user to select material before continuing
with printing.
If enabled then GERBER EDGE FX waits for
user to select foil before continuing with
printing.
CANCEL F3
MOTION F4
CANCEL F3
VERSION F4